All The Features Of The Standard SB Range With The
Added Benefit Of Oil Borne Stain Protection!
• Enables easier removal of food, beverage, oil and grease.
• Water & oil borne contaminate protection.
• Helps reduce salt ion ingress and efflorescence.
• Creates high performance sub-surface barrier.
• Low porosity distinction.
• Will not etch, alter surface texture.
• Slight darkening / highlighting effect.
• Maintains natural look of surface.
• Vapour permeable allowing surface to breath.
• Excellent for Interior and Exterior Protection.
• Ideal for pool surrounds.
• Will not flake or peel.
• Safe does not contain chlorinated hydrocarbons.
• Penetrating ” fine pore” solvent based formula.
• Food Safe
• Can be applied by:
Broom, Brush, Roller or Spray
Minimum 2 Coats
7-13 sqm / L per coat
N/A on non-porous surfaces
Touch Dry: 2 Hours
Re-coat: 20 – 30 mins
Light Traffic: 2- 6 Hours
Heavy Traffic: 24 – 48 Hours
Clean-up immediately on completion with solvent thinners.
View Real Time Stain Protection Video Footage
And Additional Information
On Our Deluxe Stain Protection Page.
Solvent Based - Deeper Penetration
Safe – No Chlorinated Hydrocarbons
Delivered Ready – No Mixing Required
Film Free - Will Never Peel or Flake
Life – Protection For Up To 8 Years
Appearance – Retains Natural Look
Protect any adjacent areas by masking to avoid splashes or over-spray onto surfaces not intended to be treated.
New installations must be fully cured before application.
Caution on newly laid stone, best to allow minimum 7 days curing prior to sealing.
Surface must be bone dry, clean and chemical free.
Do not apply in direct peak sunlight. Surface temperature must be between 10°C and 28°C.
Do not apply if rain is imminent
Apply 1 to 2 coats by generously saturating the surface using a polish applicator, roller or sprayer to an area which can be easily reached. (Approximately 15sqm). Ensure even coverage.
Apply a liberal flood coating giving whole surface a wet look.
Application must not be too thick as excessive build up may cause the coating to appear milky when subject to ponding or peel.
Apply each coat at right angles to the previous coat to ensure even coverage.
The surface must be shiny wet with a liquid film for at least 1 minute. For very porous substrates more sealer may need to be applied.
Allow 5 - 10 minutes for the sealer to absorb into the surface and then move the excess product to a new section.
Wait 5 to 20 minutes and repeat the process. Do NOT allow first coat to fully dry as will repel second coat.
Using absorbent toweling or applicator, wipe off any sealer remaining on surface after 10 minutes of last application. Do NOT allow excess residue to cure on surface as may turn white!
Allow 2 to 6 hours before returning area to traffic. Keep dry for 12 hours.
Achieves a full cure in 24-48 hours.